Milnor Mark II Handbuch Seite 15

usually be corrected at the operator controls.
RECOVERY: Press
or another message appears on the display, request authorized service.
RECOVERY: Press
RECOVERY: Press
operation. NOTE: If this machine does not have metered water, request management assistance to ensure
that the configure values match the equipment.
RECOVERY: Manually command level 2. Permit time to achieve this level, then manually
command extract. Continue manual operation. Press
—These errors usually require accessing program data and procedures found in the reference manual.
RECOVERY: Request management assistance to clear the memory and reprogram the machine.
Return to run mode to resume operation.
RECOVERY: Request management assistance to reconfigure the machine. Return to run mode
to resume operation.
The three-wire relay supplying control circuit power to the machine was
de-energized or power was restored to the machine after a shutdown or
power loss.
to close the three-wire circuit. If the three-wire circuit remains disabled
Accumulator data is unreliable.
to clear accumulator data and resume operation.
The water data is unreliable.
so the controller prompts for information. The machine resumes
Level 2 was not achieved before an extract was manually commanded.
Program data was corrupted.
Configure data was corrupted.
11
<B>D?DCB04 (#"%0E
—These errors can
to resume operation.