Parkside Performance PABSP 20-Li B2 Bedienungs- Und Sicherheitshinweise Seite 35

˜ Attaching/removing the
accessory tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use . Always
wear protective gloves when handling
accessory tools!
m
WARNING!
Always switch the product off, remove
the battery pack 10 and let the
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation .
m
CAUTION! RISK OF INJURY!
After the product has been switched off,
u
the accessory tool continues moving for
some time . Do not touch the accessory tool
and do not attempt to brake it .
This product is equipped with an automatic
spindle lock to open or close the chuck 1 with
the chuck sleeve 2 .
Open the chuck 1 : Turn the chuck sleeve
¾
2 in a counter-clockwise direction (Fig . E) .
Insert a suitable accessory tool into the chuck
¾
1 as deep as required .
Close the chuck 1 : Hold the accessory tool
¾
in position . Turn the chuck sleeve 2 in a
clockwise direction .
34 GB/IE
NOTES
This product is equipped with a Röhm drill
u
chuck with an anti-lock function .
If you attempt to open the fully opened
u
chuck 1 further, the anti-lock function will
be activated to protect the chuck .
When the anti-lock function is activated,
u
the chuck 1 cannot be closed by turning
the chuck sleeve 2 in a clockwise
direction . A ratcheting sound will be
produced when you attempt to close the
chuck .
Deactivating the chuck's 1 anti-lock
u
function: Turn the chuck sleeve 2 in a
clockwise direction by a certain extent .
Then, turn the chuck sleeve suddenly and
quickly in a counter-clockwise direction .
Repeat this action if the anti-lock function
is still active . When the anti-lock function is
deactivated, you should be able to close
the chuck 1 without ratcheting sounds .
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the gear selector
4 until the product has come to a
standstill .
Change the gear by sliding the gear selector
¾
4 forwards or backwards (fig . F) .
1 gear:
st
Suitable for:
Speed:
Torque:
Screwing
Low
High