Working Instructions; Drilling In Wood, Metal And Other Materials; Drilling In Wood; Cleaning And Care - Parkside Performance PABSP 20-Li B2 Bedienungs- Und Sicherheitshinweise

Before operating the product, check whether
¾
the accessory tool is correctly positioned, i .e .
centred in the chuck 1 .
Screw bits are labelled according to their
¾
dimensions and their shape . If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play .
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you
¾
set the torque or rotational speed too high .
Hard screw joints (in metal)
Particularly high torque occurs, for example
¾
in metal screw joints made using drive
sockets . Select a low rotational speed .
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e .g . to
¾
avoid damaging the surface of the wood
upon contact with the screw head . Use a
countersink .
Drilling in wood, metal and other
materials
Use a high speed for drill bits with small
¾
diameter and a low speed for drill bits with
large diameter .
Select a low speed for hard materials and a
¾
high speed for soft materials .
Secure or fasten the workpiece in a clamp or
¾
vice (if possible) .
Mark the spot where you want to drill
¾
using a centre punch or nail . Select a low
rotational speed when starting .
Pull the rotating drill bit from the hole
¾
repeatedly to remove dust and chips and
clear the hole .
36 GB/IE
Drilling in metal
Use a metal drill (HSS) . For optimum results,
¾
cool the drill bit with cooling lubricant
(cutting oil) . Metal drill bits can also be
used to drill into plastics . Start with a 3 mm
diameter drill bit and then increase the size
until the desired hole diameter is achieved .

Drilling in wood

Use a wood drill with a lathe centre .
¾
Deep holes: Use an auger bit .
Large-diameter holes: Use a Forstner bit .
Small screws can be screwed directly into
soft wood .
Belt clip
m
CAUTION! RISK OF INJURY!
Before hanging the product in the belt:
u
Push the rotation direction switch 5 to
the centre position (lock) . This prevents
the product from being switched on
accidentally .
The belt clip 9 allows the tool to be hooked
¾
on belt or pocket .
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack 10 and let the
product cool down before performing
inspection, maintenance and cleaning
work!