Drill Safety Warnings; Vibration And Noise Reduction - Parkside Performance PABSP 20-Li B2 Bedienungs- Und Sicherheitshinweise

7) Follow all charging instruction and
do not charge the battery pack or
tool outside the temperature range
specified in the instruction. Charging
improperly or at temperatures outside the
specified range may damage the battery
and increase the risk of the fire .
Service
Have your power tool serviced by
1)
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained .
2) Never service damaged battery
packs. Service of battery packs should be
only be performed by the manufactured or
authorized service providers .
˜ Drill safety warnings
1. Safety instructions for all operations
Hold the power tool by insulated
1)
gripping surfaces, when performing
an operation where the accessory
tool or fasteners may contact
hidden wiring. Accessory tools or
fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric
shock .
30 GB/IE
2. Safety instructions when using long
drill bits
Never operate at higher speed
1)
than the maximum speed rating of
the drill bit. At higher speeds, the drill bit
is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in
personal injury .
2) Always start drilling at low speed
and with the drill bit tip in contact
with the workpiece. At higher speeds,
the drill bit is likely to bend if allowed
to rotate freely without contacting the
workpiece, resulting in personal injury .
3) Apply pressure only in direct line
with the drill bit and do not apply
excessive pressure. Drill bits can bend
causing breakage or loss of control, resulting
in personal injury .
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment .
Take the following points into account to minimise
the vibration and noise exposure risks:
Only use the product as intended by its
¾
design and these instructions .
Ensure that the product is in good condition
¾
and well maintained .
Use correct accessory tools for the product
¾
and ensure they are in good condition .
Keep tight grip on the handles / grip surface .
¾