Conceptronic CADSLR4+ Schnellinstallationsanleitung Seite 25

ENGLISH
With the Command prompt of Windows you can verify if you have received a correct IP
address on your Local Area Connection:
7. Click "Start"
8. Enter the command "CMD" and press "OK".
The Command Prompt will appear.
9. Enter the command "IPCONFIG" and press ENTER.
You should see the following information
IP Address
Subnet Mask
Default Gateway
If the information shown above matches your configuration you can continue the
configuration of the CADSLR4(B)+ in Chapter 4.
If the shown information does not match your configuration (i.e. your IP address is
169.254.xxx.xxx) please check the options below:
A. Power OFF and Power ON the device.
B. Reconnect the LAN Cable to the device and to your computer.
C. Renew the IP address of your computer with the following commands:
- "IPCONFIG /RELEASE" to release the wrong IP address.
- "IPCONFIG /RENEW" to receive a new IP address from the device.
"Run".
: 192.168.1.xxx (Where xxx can vary between 2 ~ 254).
: 255.255.255.0
: 192.168.1.1
9
25