About This Documentation; Documentation Validity; Required And Supplementary Documentation - Aventics CVI Series Betriebsanleitung

Table 1: Documentation for optional individual devices
Device
Sensor, series SN6, ATEX certified
Sensor, series ST6, ATEX certified
Coil, series CO1, with electrical
connector, ATEX certified
AVENTICS | CVI/TUS | R412004532–BDL–001–AE
1

About This Documentation

1.1

Documentation validity

This documentation applies to the following products:
Cylinder valve units from the series CVI/TUS that are designed
for use in explosive atmospheres, consisting of one cylinder
from series PRA/TRB or 523 with Ø 32 mm–Ø 200 mm and
one valve from the series 740 or CD07.
This documentation is geared toward system planning engineers,
machine manufacturers, and assembly technicians.
This documentation contains important information on the safe
and proper transport, assembly, commissioning, operation,
maintenance, and disassembly of the product, as well as steps the
system owner can take to remedy simple malfunctions.
Read this documentation completely, especially the chapter
"Notes on Safety" before working with the product.
1.2

Required and supplementary documentation

Depending on the configuration, the cylinder valve unit contains
different individual devices (sensors and/or coils). The individual
devices are not addressed in these operating instructions.
Only commission the product once you have obtained the
relevant documentation for your configuration and understood
and complied with its contents. The table below contains a list
of the valid documentation for individual devices.
Document number
R499050077
R412004555
R499050034
About This Documentation
Document type
Operating instructions
Operating instructions
Operating instructions
45