Technical Data; Special References; Instructions - Parkside PDT 40 E4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Technical data


Dimensions:
Weight
(without fasteners):
Trigger type:
Maximum permissible
pressure:
Recommended pressure
range:
Air consumption per
drive in process:
Recommended lubricant:
Loading capacity:
Nail lengths:
5,7 mm
Staple lengths:
Staple width:
Recommended
Internal hose diameter:
Compressed air quality:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 12549:1999, EN ISO 4871.
The A-weighted sound pressure level of the device is
typically 82,0 dB(A)
Uncertainty K = 2.5 dB
Lwa: 95,0 dB(A)
Lpa (at the work station): 98,3 dB(A)
Lpc: 117,8 dB(A)
These values are characteristic values referenced to
the device and do not reflect noise development at
the work location. Noise development at the work
location depends e.g. on the work environment, the
workpiece, the workpiece support and the number
of fastener driving processes.
In correspondence with conditions at the work loca-
tion, individual noise reduction measures may need
240 x 239 x 57 mm
to be carried out, such as placing the workpiece on
(L x H x W)
a noise-suppressing surface, clamping or covering
to prevent workpiece vibration and adjusting to the
1197 g
minimum pressure required by the work process. In
Compressed air
certain cases, wearing personal hearing protection
is require.
8 bar
Vibration values in accordance with
ISO 8662-11:1999:
Vibration emission value ah = 3,199 m/s
Uncertainty K = 1,5 m/s
4 to 7 bar
Mechanical impact (vibration)
The vibration value for the fastener driving device was
approx. 0.09 litre
determined in accordance with ISO 8662-11:1999
Compressed air
— Hand-held portable power tools – Measurement of
special oil
vibrations at the handle — Fastener driving tools (see
100 pcs
technical data). The value is referenced to the device
15 mm, 20 mm,
and does not represent the influence on the hand-
25 mm, 30 mm,
arm system when the device is used. Influence on the
32 mm, 35 mm,
hand-arm system when using the device depends on
38 mm, 40 mm,
e.g. gripping force, pressing force, working direction,
45 mm, 50 mm
air pressure set, the workpiece and its position.
10–40 mm
5,7 mm

9 mm
Cleaned, oil-misted

and condensate-free
The following standard is applicable to fastener
driving tools as per EN 792-13:2000 „Hand-held
non-electric power tools – safety requirements – Part
13: Fastener driving tools". The standard requires that
▪
▪
▪
2

Special references

Instructions

Only those fasteners which are specified in the ope-
rating instructions (see technical data) shall be used
in fastener driving tools. The fastener driving tool
and the fasteners specified in the operating instruc-
tions are to be considered as one unit safety system.
Quick-action couplings shall be used for con-
nection to the compressed air system and the
non-sealable nipple must be fitted at the tool in
such way that no compressed air remains in the
tool after disconnection.
Oxygen or combustible gases shall not be used
as an energy source for compressed air opera-
ted fastener driving tools.
2
GB/CY 7