Ottobock C-Leg 3C98-2 Information Für Träger Seite 31

The standing mode is an additional functional feature of the 1st mode. It makes it easier for you to stand on an
inclined surface for a longer time. The C-Leg is fixed in the flexion direction at a flexion angle between 7° and 70°.
For individual use of the standing mode function, please proceed as follows:
Turning the standing mode function on
Requirement: The knee joint is fully bent.
Activation of the remote control:
Press key 3 and keep it pressed (Fig. 1) until the joint confirms the activation with
a vibration signal.
1
Turning the standing mode function on:
Within 3 seconds after activation of the remote control simultaneously press the
keys 1 and 2 (Fig. 2) until the joint confirms turning on of the standing mode with
three short beep signals.
2
Using the standing mode
Adjusting the standing angle
0°
7°
70°
0°
7°
70°
2
INFORMATION
Slow extension (Fig. 2): Actively standing up from sitting at this speed would take about 2 – 5 seconds.
C‑Leg
1 Flex the joint between 7 – 70° and keep it still for one second (Fig. 1).
2 Slowly extend the joint up to the desired angle (70 – 7°; Fig. 2).
3 In this position, keep the joint still for one second until the C-Leg shortly
vibrates.
4 The blocked joint can now be fully loaded in the flexion direction.
1
Ottobock | 31