Ottobock C-Leg 3C98-2 Information Für Träger Seite 29

Activating 2nd Mode
Activation of the remote control:
Press key 3 and kep it pressed (Fig. 1) until the joint confirms the activation with a
vibration signal.
1
Activation of the 2nd mode:
Within 3 seconds after activation of the remote control press key 2 and keep it pressed
(Fig. 2). You will hear two short beep signals, and the joint switches to the 2nd mode.
2
INFORMATION
If the C-Leg is in the 1st mode, this is the way to switch to the 2nd mode.
If the C-Leg is in the 3rd mode, this is the way to switch to the 2nd mode
If the C-Leg already is in the 2nd mode, this mode will be reconfirmed.
The 2nd mode remains turned on until you actively switch to the 1st mode.
INFORMATION
No provisions are made for using the remote control to switch to the 3rd mode. Switching to the 3rd mode
is only possible through specific movement patterns in the joint.
However, it is possible to switch from the 3rd mode to the 1st or 2nd mode with the remote control.
Switching between 1st and 2nd modes without the remote control:
3 × in 1 second
Bounce up and down on the forefoot at least 3 times in one second while maintaining continuous ground
1
contact. The foot must bear at least 70% of the maximum load. When relieving the foot, the foot must
bear at least 15% of the maximum load. You will hear a beep signal.
Lift the leg for at least one second and extend it to the rear (no ground contact).
2
C‑Leg
1 second
1
2
Ottobock | 29
3