Ottobock C-Leg 3C98-2 Information Für Träger Seite 34

Optimization of the damping behaviour
1 Activation of the remote control: Press key 3 and keep it pressed (Fig. 1) until the joint confirms the
activation with a vibration signal.
2 Configuration of the damping behaviour: Within 3 seconds after activation, push and hold button 3 on
the remote control again. Additionally, press key 1 or 2 briefly:
• Key 1 – change from standard to comfort or from dynamic to standard respectively (Fig. 2).
• Key 2 – change from standard to dynamic or from comfort to standard respectively (Fig. 3).
3 Signals: The successful setting of the damping parameters is confirmed acoustically with the following
beep signals:
• Comfort = 1 × beep signal
• Standard = 2 × beep signals
• Dynamic = 3 × beep signals
Pairing (Connecting the C‑Leg to the Remote Control)
CAUTION
Fault while connecting the C‑Leg and remote control (pairing). If several joints are present in close
proximity, this can result in unwanted connection of the remote control with another joint (pairing). This can
cause you to fall.
Given that only one joint can be paired with a remote control, it must be ensured that no other joint is in the
circumference of 3 m during the pairing.
INFORMATION
If the C-Leg still is in the delivery state, pairing is not required.
Pairing is done
• as soon as a new remote control (replacement) is used with the C-Leg.
• if a configuration or mode switch cannot be effected with fully charged batteries of the joint and the remote
control within the working range of the remote control (70 cm / 28 in.).
34 | Ottobock
1
Dynamic
Key 3
keep it pressed
Standard
Key 1
press briefly
Comfort
2 3
Key 3
keep it pressed
Key 2
press briefly
C‑Leg