Ce Conformity; Troubleshooting - Profitec Pro 500 Bedienungsanleitung

10 CE CONFORMITY

Conformity
The product complies with the following EU Directives:
Machine: 2006/42/EC
Low Voltage: 2006/95/EC
EMC: 2004/108/EC
PED: 97/23/EC
EN-Directives: EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75, EN 55014, EN
61000-3, EN 61000-4, ENV 50141, EN 55104

11 TROUBLESHOOTING

Problem
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
The machine is switched on, but
the machine does not work.
Weak "body"
Foam instead of crema
If the machine will not be for a long period of time, it is recommended to
.. clean the brew group (see instructions on page 18). Afterwards, please do not clamp the filter holder back
into the brew group.
Instruction manual Profitec Pro 500
Possible cause
The grind is not fine enough
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground coffee.
The orange control lamp is
switched off: there is not enough
water in the water tank.
Water was refiled, the orange
control lamp is switched off.
The water tank is not fixed
properly.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The coffee beans are improper
The setting of the coffee grinder is
not suited for the coffee beans in
use
22
Troubleshooting
Use a finer grind setting.
Tamp the ground coffee more
firmly.
Use fresh coffee
Use a chlorine filter.
Use the right coffee amount:
Approx. 7 g – 9 g of coffee for
each cup.
Clean the brew group.
Increase the grind setting.
Tamp the ground coffee only
slightly.
Use approx. 7 g – 9 g of coffee for
every cup.
Refill water.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point should face
towards the inside of the machine.
The floater itself should be
inserted with the magnet point on
the lower part of the floater side.)
Fix the water tank properly.
Reduce the grind setting.
Use fresh coffee.
Use approx. 7 g of coffee for each
cup.
Clean the shower screen.
Use another coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)