Chicco Essential Digital Audio Baby Monitor Gebrauchsanleitung Seite 16

long, otherwise the parent unit may not switch
on. Press this button (2) again for about 3 seconds
and the parent unit will switch off.
A beep will be heard when switching the parent
unit on and off.
- Loudspeaker volume adjustment buttons + and
- (3a-3b).
Press the button (3a) corresponding to the
symbol "+" once to increase volume by one
level. Press the button (3b) corresponding to
the symbol "-" once to decrease volume by one
level. The unit offers 10 volume setting levels. The
default level is 5.
A beep will be heard each time volume is increased
or decreased by a level. When volume reaches
maximum or minimum level, 2 consecutive beeps
will be heard.
The device stores the volume level selected
during previous use in its memory, even after it
has been switched off and switched back on.
- Voice activation or continuous transmission
ON/OFF selector.
The parent unit can work in continuous
transmission mode (selector in OFF position)
or in voice activation mode (selector in ON
position). In voice activation mode, the parent
unit loudspeaker (7) interrupts the reproduction
of any sounds emitted from the child that are
below the factory set default voice activation
threshold, while all sounds above the threshold
are reproduced.
- Parent unit portability.
The parent unit is equipped with a useful belt
hook (10) for carrying it around.
2.2.3 Luminous and acoustic operating status
indicators
- The power and link indicator light (5) supplies 3
different pieces of information:
- Indication that the device is on and properly
connected to child unit:
the indicator light (5) will light up steady green.
- Indication of loss or absence of link with the
parent unit during operation:
the indicator light (5) lights up green, starts to
flash and, after about 10 seconds, 2 consecutive
beeps per second are heard.
As soon as the link is restored, the beep will
switch off and the indicator light (5) will light up
steady green.
NOTE: when the parent unit switches on, it
searches for the channel to link with the child
unit; therefore the indicator light (5) will flash
green until a link is established.
-Indication of device off:
the indicator light (5) will switch off.
- The rechargeable lithium-ion battery status
indicator light (6) supplies 3 different pieces of
information:
-Indication that the rechargeable battery (13) is
almost flat:
the indicator light (6) lights up red, starts to flash
and, at the same time, one beep per second are
heard. If you want to continue using the device,
it is advisable to charge the rechargeable lithium-
ion battery (13); otherwise, the device will stop
working. Charge the rechargeable lithium-ion
battery (13) by connecting the mains adapter (1)
to the parent unit power and charger connector
(12). When charging starts, the beep will switch off.
-Indication that the rechargeable battery (13)
is charging: when charging begins, the indicator
light (6) switches on steady red.
Leave the battery to charge until the indicator
light (6) switches off.
The parent unit can still be used to monitor
sounds made by the child while the rechargeable
battery is charging, but the time required to reach
full charge will be longer.
-Indication that the rechargeable battery is
charged or of operation via mains adapter (1)
without rechargeable battery:
the indicator light (6) will switch off.
- Lit level indicator bar for sounds emitted by the
child (4):
Illuminates progressively
outward, indicating 3 levels of sound intensity
coming from the child unit microphone (7).
Allows parents to monitor sounds emitted by the
child even when the parent unit (7) loudspeaker
volume is switched off.
sounds emitted by the child are of a relatively
low intensity.
emitted by the child are of medium intensity.
emitted by the child are of a relatively high
intensity.
Warning!
After switching on the parent unit always check
the power status of the child unit !
After switching on the unit, always check that
reception of the transmitted signal is possible at
16
from the
: the central LED lights up if
: 3 LEDs light up if sounds
: 5 LEDs light up if sounds
centre