Mitel 5550 IP Console Installationshandbuch Seite 16

Console keypad – Default key programming
The console keypad features 12 programmable keys with removable
keycaps and labels. The keypad comes with features already
programmed on the keypad. Apply the labels as shown below,
depending on the Release of your console.
If you have Release 3.0 or higher, apply the programmable key
labels as follows:
SCRATCH
PAD
PHONE
BOOK
*BLF = BUSY LAMP FIELD
If you have Release 2.1 of the console, apply the programmable key
labels as follows:
SCRATCH
PAD
PHONE
BOOK
*BLF = BUSY LAMP FIELD
If you have Release 2.0 of the console, apply the programmable key
labels as follows:
SCRATCH
PAD
PHONE
BOOK
You can reprogram keys to different locations, assign other features
to them (for example, Emergency Calls), or disable keys that are not
required. For programming instructions, see Firmkey Programming in
the 5550 IP Help.
When removing keycaps to change labels, grasp the keycap
between your thumb and forefinger, and then lift. If necessary, use a
screwdriver or other tool to gently pry off the keycap. When replacing
the keycap, push down firmly to seat it onto the key.
8
BULLETIN VOICE
BOARD MAIL
INCOMING
BLF*
CALLS
BULLETIN GUEST
BOARD SERVICES
INCOMING
BLF*
CALLS
BULLETIN GUEST
BOARD SERVICES
TRUNK
BLF
STATUS
MESSAGE
PAGER
WAITING
TRANS-
CALLS ON
FERRED
HOLD
CALLS
MESSAGE
PAGER
WAITING
TRANS-
CALLS ON
FERRED
HOLD
CALLS
PAGER HELP
MESSAGE
TONES
WAITING
TONES
PARKED
CALLS
TONES
VOICE
MAIL
OPERATOR
MODE
VOICE
MAIL
English