Date And Time Setting; Clear Hard Disk - Avtech AVC792 Schnellstart

3.5 Date and Time Setting

Before operating your DVR, please set the date and time on your DVR FIRST.
Note: Please DO NOT change the date or time of your DVR after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it's recommended to clear all HDD data, and start recording again.
Note: For the first time to use the DVR, please power it on for at least 48 hours continuously after the
date & time is set correctly. It helps to prevent DVR time from resetting after the disconnecting
of DVR power. If the DVR time resets after the disconnecting of DVR power, for example, caused
by a power outage, the battery might run out and please replace the battery as described in
"APPENDIX 6 DVR BATTERY REPLACEMENT" at page 27.
Right-click to enter the DVR password with the password keypad. The default administrator password is 0000.
The status will be changed from
and select "QUICK START"  "TIME SETUP" to set the date & time.
GENERAL
TIME SETUP
EXIT

3.6 Clear Hard Disk

It's recommended to clear all data in the hard disk for the first time to user this DVR to ensure the recorded data
are not mixed with other data previously saved in the same hard disk.
Right-click to show the main menu, and select "SYSTEM"  "SYSTEM INFO"  "CLEAR HDD". The DVR will
reboot when HDD data are cleared.
ACCOUNT
TOOLS
SYSTEM INFO
BACKUP DATA (USB)
BACKUP LOG (USB)
EXIT
(key lock) to
QUICK START
DATE
TIME
SYSTEM
BAUD RATE
HOST ID
R.E.T.R
AUTO KEY LOCK
CLEAR HDD
RESET DEFAULT
REMOTE CONTROL ID
SERIAL TYPE
VIDEO FORMAT
VERSION
(administrator). Then, right-click to show the main menu,
2009 / NOV / 17
15 : 35 : 53
2400
000
5
NEVER
HDD-0
SUBMIT
000
1025-1011-1011-1012
10
RS485
NTSC