Camera Connection; Power Setup; Date And Time Setting - Avtech KD673 Schnellstartanleitung

Step 4: Align the screw hole on the each bracket with the screw hole on the each side of the HDD as shown
below, and fix the HDD to the bracket with a HDD screw supplied.
Step 5: Close the upper cover of the DVR, and fasten all the screws you loosened in Step 1.

3.2. Camera Connection

The cameras must be connected and power-supplied. And then connect the camera video output to the DVR
video input port with a coaxial cable or RCA lines with BNC connectors. The DVR will automatically detect the
video system of the connected camera(s) (NTSC / PAL), and switch itself to the correct system.
1) Power connection
Connect the camera with indicated power supply.
2) Video cable connection
Connect the camera video output to the DVR video input port with a coaxial cable or RCA line with BNC
connector.
3) Audio cable connection (Selected models only)
Connect the camera audio output to the DVR audio input port with a coaxial cable or RCA line with BNC
connector.
4) Camera Setup (PTZ cameras only)
For detailed camera title, ID, protocol and baud rate setup, please refer to "5.5. REMOTE" in the user manual.
3.3. Optional Peripheral Connection (Selected models only)
Depending on the DVR model you have, this DVR series may support to connect other peripherals. For detailed
connection, please refer to their own user manuals.

3.4. Power Setup

This device should be operated only with the type of power source indicated on the manufacturer's label. Connect
the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED will be on. It
takes approximately 10 to 15 seconds to boot the system.
Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply, for continuously operation. (Optional)

3.5. Date and Time Setting

Before operating your DVR, please set the date and time on your DVR first.
Press "MENU" and enter the password to go to the menu list. The default admin password is 0000. Move to
"DATE" and you can set the date / time / daylight saving in the "DATE" menu list.