VATECH PAX-i3D Smart Bedienungsanleitung Seite 32

3.2.3
PaX-i3D Smart(PHT-30LFO) User Manual
Completing Patient Positioning
1. After confirming patient positioning and beam alignment, adjust the temple
supports to fit snugly on both sides of the patient's head by clicking the temple
support adjustment button.
Make sure that the Temple Support is in Close position
before clicking the READY button.
CAUTION
2. Click the Ready button after the patient has been properly positioned. No
X-Ray will be emitted at this point.
3. Proceed to section 3.3 Initiating X-Ray Exposure.
4. When the Temple Support is open, guide the patient out of the equipment.
TMJ Close
Scan a TMJ Open image first and then scan a TMJ Close
image. Guide the patient to close his/her lips for TMJ Close
imaging while maintaining the same position used for TMJ
NOTE
Open imaging.
1. Shortly after TMJ Open imaging has been completed, you will receive the
following message: "Do you want to take the TMJ Close image continuously?"
Press the OK button to capture a TMJ Close image.
2. Guide the patient to the inside of the equipment.
3. Have the patient place his / her acanthion point on the chin support and tilt
his / her head forward by 5 degree.
3 Acquiring PANO Images
31