Assembly; Operation; Switching On/Off; Work Breaks - Parkside PNTS 1500 B2 Originalbetriebsanleitung

Assembly

Pull out the mains plug.
Danger of electric shock.
1. Attach the feet (6) to the housing:
- The feet with wheels (6a) num-
bered
into the appropriate adaptors
on the rear side of the waste
collector (see
- The feet with guide rollers
(6b) must be fitted to the hold-
ers on the front side of the
container (5).
2. Secure the feet with the Philips
head screws supplied.
3. Place the motor housing (3) on
top of the collector (5) and close
it with the clip.
4. Lightly squeeze together the
ends of the retaining bracket
(25) and click it into the motor
housing (3).
5. Installing the accessories:
- Attach the vacuum hose (18).
- Install the telescopic suction
tube (16). (Press the button on
the telescopic suction pipe to-
wards
desired length).
- Install the nozzle desired (
21/22/23/24).
Never vacuum without a
filter!

Operation

Switching on/off

Connect the mains plug.
To vacuum dust, plug the electrical
tool onto the mains socket on the
vacuum (
+ must be fitted
 ‚
small picture).
and pull out to the
9).
Only connect electrical appliances
with a maximum power rating of
1400 W.
Switching on the vacuum cleaner
(Permanent operation):
Move the On/Off switch (
position.
Switch on electrical appliance +
vacuum cleaner:
1. Move the On/Off switch
10) to the position
(
2. Switch on electrical appliance.
Switching on the electrical appli-
ance automatically switches on the
vacuum cleaner. Once the electrical
appliance has been switched off,
the vacuum cleaner switches off fol-
lowing a time lapse.
Switching off the vacuum cleaner:
Move the On/Off switch (
"0" position.

Work breaks

To store the assembled suction set during
a work break, the telescopic suction tube
(16) can be pushed
together and the suction tube holder

(17) plugged into the socket on the mo-
tor head (3);
Place the telescopic suction tube (16)
‚
in the retaining bracket (25).

Dry vacuuming

1. To vacuum dry, fit the fluted filter (11a)
onto the filter cage on the motor hous-
ing (3). Here, the upward curved seal-
ing lip must point away from the motor
housing.
GB IE CY
10) to the "I"
10) to the
9