Manual Initialization Of Part-Turn Actuators; Service And Maintenance - Siemens 6DR5 Serie Kompaktbetriebsanleitung

5. Start the initialization process. To do this, press the
The positioner runs through five initialization steps during the automatic initialization process. Displays for the
initialization steps from "RUN1" to "RUN5" are shown in the lower line on the display. The initialization process depends
on the actuator used, and takes up to 15 minutes.
6. The following display indicates that the automatic initialization is complete. The total angle of rotation of the actuator is
shown on the upper line on the display:
Aborting the automatic initialization process
1. Press the button. The display shows the following:
The positioner is in the "Configuration" mode.
2. Exit the "Configuration" mode. To do this, press the
The software status is displayed.
After releasing the
5.7.3

Manual initialization of part-turn actuators

See detailed operating instructions for information on manual initialization of part-turn actuators.
6

Service and maintenance

6.1 Basic safety instructions
WARNING
Impermissible repair of the device
● Repair must be carried out by Siemens authorized personnel only.
WARNING
Impermissible accessories and spare parts
Danger of explosion in areas subject to explosion hazard.
● Only use original accessories or original spare parts.
● Observe all relevant installation and safety instructions described in the instructions for the device or enclosed with the
accessory or spare part.
32
button, the positioner is in "P manual mode". The part-turn actuator is not initialized.
button for at least 5 seconds until the display shows the following:
button for at least 5 seconds.
SIPART PS2 (6DR5...)
A5E03436620-02, 01/2013