Maintenance Plan - Summary Table - maschio BUFALO Gebrauch Und Wartung

ENGLISH

5.1 MAINTENANCE PLAN - Summary table

INTERVAL
WHEN THE MACHINE lS NEW
EVERY 8 WORKING HOURS
EVERY 50 WORKING HOURS
EVERY 400 WORKING HOURS
REST PERIODS
It is in the interests of the user to follow these instructions carefully, as when work recommences, he will fi nd the
equipment in perfect condition
LUBRICANTS
- It is advisable to use AGIP ROTRA MP SAE 85W/140 OIL
or equivalent for the overdrive unit. Correspond to following
specifi cations API - GL5 / MIL-L-2105C.
- It is advisable to use AGIP GR MU EP 2 GREASE or
equivalent for all greasing points.
60 - EN
USE AND MAINTENANCE
- Grease all parts indicated by transfer nr. 17 ('GRASE') at page 45 of this leafl et.
- Lubricate all the transmission chains with mineral oil (SAE 80W/90).
- After the fi rst hours of work check that all the bolts are still tight.
- Grease the cardan shaft cross journals.
- Grease the bearings of the rotor.
- Check the tightness of the fastening bolts of the blades.
- Open the rear hood and check to make sure that the rotor housing is clean and free from
plant residues.
-
Check the oil level in the overdrive box and the transmission shaft, fi lling it up, if necessary,
to the notch on the indicator (
-
Carry out a complete oil change of the overdrive, discharging all the oil from the discharge
cap located below the overdrive box (
At the end of the season, or if a long period of rest is foreseen it is advisable to:
1) Wash the equipment thoroughly with water, especially the chemical substance hoppers,
then dry them. Clean the electrical components only with a dry cloth.
2) Carefully check for worn or damaged parts and replace then where required.
3) Check the state of wear of the transmission chains and toothed wheels. Replace damaged
or worn out parts, if required. Use solvent to clean the transmission chains, the toothed
wheels and the chain stretchers. Lubricate with mineral oil (SAE 80W/90) when dry.
4) Adjust the belt of the diffusion air pump and and replace it if necessary.
5) Firmly tighten all screws and bolts.
6) Apply protecting oil to all unpainted parts.
7) Protect the equipment with a (nylon) cover.
8) Then position it stably in a dry place out of the reach of unauthorized people
TYPE OF WORK
fi g.42
).
fi g.42
).
QUANTITÀ DI OLIO / OIL QUANTITY
OIL
fi g.42
MOD Q. ( lt. )
ty
250
3,00
280
3,04
300
3,12
cod. F07011320