Useful Advice For The Tractor Driver - maschio BUFALO Gebrauch Und Wartung

CAUTION
Avoid idling the machine when away from the ground.
While at work, avoid working in reverse gear or taking
curves with the machine lowered (fi g.38).
Always raise the machine when changing direction or
reversing gears (fi g.39).
During transport, and whenever raising the machine
becomes a necessity, the hoisting unit of the tractor
should be regulated in order that the shredder is never
raised from the ground more than 30-35 cm (fi g.40).
Do not drive on public highways if the machine is dirtied
with soil, grass or anything else that could dirty and/or
hamper the road traffi c.
Lower the machine slowly.
Do not allow it to drop violently on to the ground. To do
this would strongly stress all the machine components
and could damage them.
4.16 USEFUL ADVICE FOR
THE TRACTOR DRIVER
The following are some useful suggestions for problems
which might arise during work.
Excessive cutting of the product to be sheared
- Slightly raise the machine from the ground, adjusting the
height with the wheels (the shredder must not touch the
ground with the blades).
- Increase the forward speed.
Scant cutting of the product to be sheared
- Slightly lower the machine to the ground.
- Reduce forward speed.
- Do not work on ground that is too damp.
Clogging of the rotor
- Ground too wet to work.
- Raise the machine from the ground.
- Reduce forward speed.
- Avoid working in presence of very tall grass. Eventually
clean away what has collected on sides of rotor in order
to prevent excessive overheating.
Clogging in the rotor compartment
- Soil too wet. Very tall grass.
- Stop the engine.
- Make sure that all moving parts are at a standstill.
- Thoroughly clean all the accumulated material from the
rotor compartment with an adequate tool.
The machine bounces on the ground, or vibrates
- Foreign bodies are caught in the blades.
- Blades mounted incorrectly, without the helicoidal arrange-
ment, or with the edge penetrating into the ground.
- Blades worn or broken.
- Deformation of the rotor due to blows received from foreign
bodies in the central part, during work.
Other inconveniences
The machine does not work in the same way along all its
width, e.g. it shreds more on the right side.
Shorten the right arm.
cod. F07011320
USE AND MAINTENANCE
fi g.37
fi g.38
fi g.39
fi g.40
ENGLISH
MAX 10 Km/h
EN - 57