Optimal Operation - INVENTOR U5MRSL32-18 Benutzerhandbuch

Manual Operations And Maintenance
Energy Saving Tips
While two or more indoor units are simulta-
neously operating, make sure the modes do
not conflict with each other. The heat mode
claims precedence over all other modes. If
the unit intially started to operate in HEAT
mode, the other units can operate in HEAT
mode only. For example: If the unit intially
started operates under COOL (or FAN) mode,
the other units can operate under any mode
except HEAT. If one of the unit selects HEAT
mode, the other operating units will stop
operation and diplay(for units with display
window only) or the auto and operation
indication light will flash rapidly, the defrost
indication light will turn off, and the timer in-
dication light will remain on (for units without
a display window). Alternatively, the defrost
and alarm indication light (if applicable) wil
light up, or the operation indication light will
flash rapidly, and the timer indication light
will turn off (for the floor and standing type).
Maintenance
If you plan to leave the unit idle for a long time,
perform the following tasks:
1. Clean the indoor unit and air filter.
2. Select FAN ONLY mode and let the indoor
fan run for a time to dry the inside of the
unit.
3. Disconnect the power supply and remove
the battery from the remote control.
4. Check components of the outdoor unit
periodically. Contact a local dealer or a
customer service centre if the unit requires
servicing.
NOTE: Before you clean the air conditioner,
be sure to switch off the unit and discon-
nect the power supply plug.
◄ Page 10 ►

Optimal operation

To achieve optimal performance, please note
the following:
• Adjust the direction of the air flow so that it
is notblowing directly on people.
• Adjust the temperature to achieve the high-
est possible level of comfort. Do not adjust
the unit to excessive temperature levels.
• Close doors and windows in COOL mode or
HEAT mode.
• Use the TIMER ON button on the remote
controller to select a time you want to start
your air conditioner.
• Do not place any object near the air inlet or
air outlet, as the efficiency of the air condi-
tioner may be reduced and the air condition-
er may stop running.
• Clean the air filter periodically, otherwise
cooling or heating per formance may be
reduced.
• Do not operate unit with horizontal louvre in
closed position.
Suggestion:
For units that feature an electric heater,
when the outside ambient temperature is
below 0°C(32°F), it is strongly recommend-
ed that you to keep the machine plugged
in so as to guarantee smooth operation.
When the air conditioner is to be used again:
• Use a dry cloth to wipe off the dust accu-
mulated on the rear air intake grille in order
to avoid the dust being dispersed from the
indoor unit.
• Check that the wiring is not broken off or
disconnected.
• Check that the air filter is installed.
• Check if the air outlet or inlet is blocked after
the air conditioner has not been used for a
long time.
3