Bosch T 12 200 E Betriebsanleitung Seite 6

6 EN
1. Controls and indicators -furietiotis
Fig. 1: T 12 200 E (Illustration not binding)
1 Measuring Instrument with various scales for test result indicati-
on.
A Voltage in Volt
B Charging condition in %
C Starting capacity in %
D Battery condition good to defective
2 Red light-emitting diode - device too not, wait until cooled.
3 Green light-emitting diode - battery testable.
4 Yellow light-emitting diode flashing - test running.
5 Yellow light-emitting diode - load resistor switched on.
6 Red light-emitting diode - battery not testable; remaining capacity
too Iow; first. Charge battery, then test.
7 Green light-emitting diode - test ended.
8 789 929 499 (2005-01-10)
8 Pushbutton - the test sequence is started by pressing this pushbutton.
9 Display selector switch - for interrogation of the various test results.
Key:
A Voltage in Volt
B Charging condition in %
C Starting capacity in %
D Battery condition
10 a) T12200 E
Current selector swith - for setting the battery size in cold test
current (A) or nominal capacity (Ah).
b) T12300 E
Current selector switch for setting the cold test current 300 A-700
A (without marking of capacity ränge in Ah).
T 12200E / T 12300E
Robert Bosch GmbH