Recommendations; Cleaning And Maintenance; Cleaning The Filter - Zodiac VORTEX 3 Montage- Und Gebrauchsanleitung

2-Notice CO ANG.qxd 13/09/10
Procedure for activating this mode:
1- Connect the control unit to the main power supply.
2- If you want the robot to automatically run a bottom only cycle, press
3- If you want the robot to automatically run a bottom and walls only cycle, press
(more than 3 s).
4-The 2 diodes will blink simultaneously:
5- The next time it will be powered up, the robot will run automatically.
To cancel the automated start mode:
1- Connect the control unit to the main power supply. Press the
2-The 2 diodes will blink simultaneously:
3.8. RECOMMENDATIONS FOR USE
•
Use your cleaner as often as possible. You will benefit from a pool that is always clean and
the filter will not become clogged.
•
The cleaner must operate in pool water maintained at the following levels: Chlorine < 2ppm,
pH between 6.8 and 7.6, temperature between 10°C and 35°C.
•
Do not leave the cleaner in the water permanently.
•
Do not leave the control box in direct sunlight after having used the cleaner.
•
If part of the pool is not properly cleaned, change the place where you immerse the cleaner until
you find the best position.
•
The cleaner's behaviour is strongly influenced if the cable is tangled. Spread the cable out in the
sun from time to time so that it recovers its original shape.
•
The behaviour of the cleaner can be influenced by the jet at the pool return outlets especially
when the filter pump is operational. In this case we recommend that you start your cleaner
when the filter pump is not operational.
IMPORTANT: Do not use your cleaner during shock chlorination!

4.1. CLEANING THE FILTER

We advise you to clean the filter after each use.
REMINDER: Make sure the power supply cable is disconnected from the power outlet or that
the floating cable is disconnected from the control box.
•
Press on button
•
Lift the cover (11-2) completely until it remains in a vertical position.
•
Remove the filter holder using its handle (11-3).
•
Press on the filter holder button (11-4) and then push the filter backwards (11-5).
Diagram 11
9:12 Page 20

4 / CLEANING AND MAINTENANCE

(Diagram 11-1) on the filter access cover.
+
.
key (more than 6 s).
.
20
(more than 3 s).
+