Remote Controlled Mode (Vortex Tm 4); Powered From The Mains (Vortex Tm 4) - Zodiac VORTEX 3 Montage- Und Gebrauchsanleitung

2-Notice CO ANG.qxd 13/09/10
Before removing the cleaner from the pool, disconnect the power cable and disconnect the
floating cable from the control box.
Bring the cleaner towards you, by gently
pulling on the cable
soon as the robot is within reach, take
hold of it using the handle (10-2) and
gently remove it from the pool, allowing
the water it contains to drain back into
the pool (10-3).
WARNING: Do not pull on the cable to remove the cleaner from the water.
3.6. REMOTE CONTROL MODE (VORTEX
You can steer the robot freely using the remote control unit. There are 4 keys on the
remote unit:
•
Forward
•
Reverse
•
Turn right
•
rotation à gauche
To use the remote control feature, simply press a key
when the robot is operational in the swimming pool. Simply press briefly the "forward" and
"reverse" keys to control the robot accordingly. Maintain the "right" or "left" keys to turn the
robot in the corresponding direction.
When in use, the two diodes
To revert to the automatic mode:
•
Do not use the remote control keys for 45 seconds minimum.
•
Do not press the
Pairing procedure:
If you need to replace the control unit or the remote control unit, you will need to pair the
new unit with the control unit. To this effect:
1- Connect the robot to the control unit then connect the control unit to the main power supply.
2- Press
3- Hold down the
4- 9.
simultaneously.
5- The remote control is correctly synchronised when the diodes turn off.
3.7. TRIGGERED VIA THE MAIN POWER SUPPLY (VORTEX
In this mode the control unit can launch a preset
detects an external power source (timer).
The cycle can be either a bottom only cycle
the diode for the corresponding programme will blink.
Regardless of the cycle, the cleaning time is 2 hrs 30 min. This duration can not be chan-
ged. Program the timer for a minimum operation time of 3 hours.
9:12 Page 19
10-1). As
(Diagram
or key.
+ for more than 6 seconds until the 2 diodes blink
key on the remote control.
The diode on the right will blink 5 times
.
TM 4)
Turn left
Forward
will blink alternately.
then the two diodes will blink
or cleaning cycle when the unit
or a bottom and walls cycle
19
Schéma 10
Turn right
Reverse
.
TM 4)
: