Initial Usage - Functioning; Recommendations - Zodiac Pool First O'Clair Montage- Und Gebrauchsanleitung

2-Notice Poolfirst ANG_Mise en page 1 05/01/11 11:06 Page16
The robot starts up after just a few seconds. The indicator light for the programme selected
comes on.
If you wish to stop the robot during the cycle, press the
You can change the cleaning cycle at any given time whilst the robot is in operation. Simply press
the button for the other cycle (3h or 1h30).
NB:
If you press the button for the cycle that is already running,there is no change in
the programme.
At the end of the cycle, the robot stops. The light remains on toindicate that the unit is still live.
Press the
Disconnect the power supply cable from the mains plug.
Disconnect the cable from the control unit and wrap it in large coils.
If you wish to initiate a new cycle after the robot has stopped, press the button
a few seconds before restarting your Pool First.
IMPORTANT: Wait for approximately 1/4 of an hour after the endof the cycle before
removing the robot from the water.

RECOMMENDATIONS

Use your automatic cleaning robot as often as possible. You will enjoy a swimming pool that is
always clean and the filter bag will clog up less often.
IMPORTANT:
The robot must operate in swimming pool water that has the following properties:
Chlorine < 2mg/l, pH between 6.8 and 7.6, temperature between 10°C and 35°C.
Do not leave the robot permanently in the water.

INITIAL USAGE - FUNCTIONING

To start the robot, select a cycle on the control unit:
> The 3h Cycle, for a meticulous clean of your pooland the waterline.
> The 1h30 Cycle, for a rapid clean cycle, if the pool is not very dirty.
To start your Pool First robot, press the programme button (3h or 1h30).
button.
OK
IMPORTANT: Do not use your robot after using a
chlorine shock treatment in your swimming pool!
Do not pull on the cable to lift the robot out of the
water. Use only the handle.
.
16
button.
and wait