Preparing For Cold Lamination - UNITED OFFICE ULG 300 B1 Bedienungsanleitung

Preparing for cold lamination

CAUTION
► After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination. Bear in mind, the rollers inside the lamina-
tor will still be hot. This could damage the laminating pouch and the docu-
ment to be laminated!
♦ Place the pouch guide rail
rear of the laminator.
♦ Pull out the document supports
slot for manual pouch insertion
♦ Insert the plug of the laminator into a mains power socket.
♦ Set the ON/OFF switch
♦ Set the selector switch for hot and cold lamination
NOTE
► Note: for cold laminating, always set the pouch thickness switch
125 μm. The red ON/OFF indicator lamp
"Ready"
♦ Place the document to be laminated into a laminating pouch of the appropri-
ate size.
NOTE
► Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig. 1.
► Make certain that you use only one pouch for laminating. First flip it up, as
shown in Fig. 2.
► For further information about the lamination process, please read the section
Lamination process.
ULG 300 B1
into the holes designed for this purpose on the
so that the documents are pulled into the
to "ON" (I).
light up.
straight.
to "COLD" (O).
and the green indicator lamp
GB │ IE │ NI
to
│
9 ■