Preparing For Cold Lamination - UNITED OFFICE ULG 300 B1 Bedienungsanleitung

Preparing for cold lamination

CAUTION
► After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination . Bear in mind, the rollers inside the lamina-
tor will still be hot . This could damage the laminating pouch and the docu-
ment to be laminated!
♦ Place the pouch guide rail 1 into the holes designed for this purpose on the
rear of the laminator .
♦ Pull out the document supports q so that the documents are pulled into the
slot for manual pouch insertion 5 straight .
♦ Insert the plug of the laminator into a mains power socket .
♦ Set the ON/OFF switch 7 to "ON" (I) .
♦ Set the selector switch for hot and cold lamination 8 to "COLD" (O) .
NOTE
► Note: for cold laminating, always set the pouch thickness switch e to
125 µm . The red ON/OFF indicator lamp 9 and the green indicator lamp
"Ready" 6 light up .
♦ Place the document to be laminated into a laminating pouch of the appropri-
ate size .
NOTE
► Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig . 1 .
► Make certain that you use only one pouch for laminating . First flip it up, as
shown in Fig . 2 .
► For further information about the lamination process, please read the section
Lamination process .
ULG 300 B1
GB │ IE │ 25 ■