Switching Levels; Preparing For Hot Lamination - UNITED OFFICE ULG 300 B1 Bedienungsanleitung

Switching levels

Selector switch
position
COLD
NOTE
► For high-gloss photos, you should choose the setting "125" as well as well
as the corresponding laminating pouch thickness.

Preparing for hot lamination

♦ Place the pouch guide rail
rear of the laminator.
♦ Fold out the document supports
slot for manual pouch insertion
♦ Insert the plug of the laminator into a mains power socket.
♦ Set the ON/OFF switch
♦ Set the selector switch for hot and cold lamination
♦ Set the pouch thickness switch
section Switching levels). The red ON/OFF indicator lamp
The laminator heats up to operating temperature.
As soon as the green indicator lamp "Ready"
reached its operating temperature.
NOTE
► The attainment of the operating temperature is indicated by the lighting
up of the green indicator lamp "Ready"
result we recommend, especially for thinner foils (below 125 μm), and
after adjustment to a different foil thickness, that you first wait an additional
2–3 minutes before starting the lamination.
► It is possible that the green indicator lamp "Ready"
out and lights up again. This means that the appliance is maintaining the
temperature and has heated up again a little. This is not a malfunction of
the appliance!
♦ Place the document to be laminated into a laminating pouch of the appropriate
size.
ULG 300 B1
Pouch thickness
switch
HOT
HOT
to "ON" (I).
Laminating pouch
position
80
125
125
into the holes designed for this purpose on the
so that the documents are pulled into the
straight.
to the desired pouch thickness (see also
lights up, the laminator has
. For a more uniform laminating
thickness
> 60–80
85–125
up to 200
to "HOT" (I).
lights up.
occasionally goes
GB │ IE │ NI │
7 ■