Video Signal Output Of An Analogue Camera - Videotec MAXIMUS MHX Bedienungsanleitung

7.3.5.3 Connection of the camera's
power line in 12Vdc, 24Vac, 120Vac and
230Vac (with power supply)
Remove the removable connector from the board.
Carry out the wiring between the removable
connector and the camera's power supply terminals.
Re-insert the connector into the board.
CONNECTION OF THE CAMERA TO THE POWER SUPPLY
Input voltage of the
camera/lens
230Vac
120Vac
24Vac
12Vdc
Tab. 6
Fig. 28
26
Input voltage of the housing
12Vdc 24Vac 230Vac 120Vac
– – J6
– – –
– J7 J7
J13 J13 J13
J13
J6 J7
7.3.6 Video signal output of an
analogue camera
The installation is type CDS (Cable
Distribution System), do not connect it to
SELV circuits.
If a camera is installed without the use of an analogue
fibre optic transmitter the video signal will be
released directly through the input/output device
cables.
Suggested coaxial cables are:
• RG59
–
• RG174A/U UL1354
J6
Slide the coaxial cable along the entry device.
J7
Connect the coaxial cable to the camera's BNC video
J13
connector. Use a 75Ohm BNC male connector (not
supplied).
Fig. 29
MNVCMHX_1432_EN