Inserting The Flux-Cored Wire - Parkside PFDS 120 A2 Bedienungs- Und Sicherheitshinweise

Assembly
z Inserting the flux-cored
wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work in order
to prevent the risk of an electric shock, injury
or damage.
Please note: Different welding wires will
be needed depending on the application.
Welding wires with a diameter of
0.6 - 1.0 mm can be used with this device.
Feed roll, welding nozzle and wire cross-
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
Unlock and open the cover of the wire
„
feed unit by raising the threaded rod
1
along the elongated hole.
Unlock the roller unit by turning the roller
„
mount anti-clockwise (see Fig. F).
29
Pull the roller mount
„
(see Fig. F).
Please note: Make sure that the end of the
wire does not come loose and cause the roll
to roll out on its own. The end of the wire
may not be released until during assembly.
Completely unpack the flux-cored wire
„
welding reel , so that it can unrolled
17
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft. Make
„
sure that the roll unwinds on the side of
the wire feed guide (see Fig. G).
31
Place the roll mount
„
lock it by pressing and turning it clock-
wise (see Fig. G).
Undo the adjustment screw
„
it upwards (see Fig. H).
Turn the thrust roller unit
„
(see Fig. I).
Loosen the feed roll holder
„
16
GB
off the shaft
29
back on and
29
and swing
27
to the side
28
by turning
30
it anti-clockwise and pull it upwards and
off (see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thickness is
indicated. If necessary, the feed roll has
to be turned over or replaced. The sup-
plied welding wire (Ø 0.9 mm) must be
used in the feed roll
wire thickness of Ø 0.9 mm. The wire
must be positioned in the upper groove!
Erect the feed roll holder
„
screw clockwise direction.
Remove the torch nozzle
„
it clockwise (see Fig. K).
Unscrew the welding
„
(see Fig. K).
Guide the cable assembly
„
the welding device as straight as possi-
ble (place it on the floor).
Take the wire end out of the edge of the
„
spool (see Fig L).
Trim the wire end with wire scissors or
„
a diagonal cutter in order to remove
the damaged, bent ends of the wire
(see Fig. L).
Please note: The wire must be kept
under tension the entire time in order to
avoid a releasing and a roll out! There-
fore it is recommended to carry out the
work with an additional person.
Push the flux-cored wire through the wire
„
feed guide (see Fig. M).
31
Guide the wire along the feed roll
„
and push it into the cable assembly
holder (see Fig. N).
32
Swivel the thrust roller unit
„
the feed roll (see Fig. O).
19
Mount the adjustment
„
(see Fig. O).
Set the counter pressure with the adjust-
„
ment screw. The welding wire must be
firmly positioned between the thrust roller
and feed roll in the upper guide
19
without being crushed (see Fig. O).
Switch on the welding device on the
„
main switch.
5
Press the torch button
„
, check
19
with the specified
19
again and
30
by turning
9
nozzle
15
away from
12
19
towards
28
screw
27
.
11