Parkside PFDS 120 A2 Bedienungs- Und Sicherheitshinweise Seite 9

been instructed in how to use
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and
day-to-day maintenance must
not be performed by children
without supervision.
Only allow qualified electricians
„
to carry out repairs and/or
maintenance work.
Only use the welding cables
„
(PFDS 120 A2 H01N2-
D1x10 mm²) included in the
scope of delivery.
During operation, the device
„
should not be right against
the wall, covered or wedged
between other devices so that
sufficient air can always be
absorbed from the ventilation
slots. Please ensure that the
device is correctly connected
to the mains voltage. Avoid
any tensile strength on the
power cable. Pull the mains
plug out of the socket prior
to setting the device up in
another location.
If the device is not in opera-
„
tion, always switch it off using
the ON/OFF switch. Place the
electrode holders on an insu-
lated surface and only remove
the electrodes from the hold-
er after 15 minutes of cooling
down.
Pay attention to the condition of
„
the welding cable, electrode
holder and the earth terminal.
Wear and tear of the insulation
and the live parts can lead to
hazards and reduce the quality
of the welding work.
Arc welding creates sparks,
„
molten metal parts and
smoke. Therefore ensure that:
All flammable substances
and/or materials are removed
from the work station and its
immediate surrounding.
Ensure the work station is
„
ventilated.
Do not weld on containers,
„
vessels or tubes that contain or
contained flammable liquids or
gases.
form of direct contact with the
welding current circuit. The
open circuit voltage between
the electrode holder and earth
terminal can be dangerous,
there is a risk of electric shock.
Do not store or use the device
„
in a damp or wet environment
or in the rain. Protection
rating IP21S is applicable in
this case.
Safety instructions
Avoid any
9
GB