Switching Off The Scale - Seca 232 n Gebrauchsanweisung Und Garantieerklärung

Switching off the scale

56 •
NOTE
Follow the administrator manual for the configuration software and for
the barcode scanner. seca Service will be pleased to assist if you have
any questions.
1. Press the Start key.
All the elements of the display are shown briefly, then
display.
The scale is operational when
If the scale is operated with a power supply unit, the
the display.
If a digital measuring rod is connected to the scale, the measuring rod is
switched on automatically (see "Measuring with the digital measuring rod"
from page 55).
2. Place the baby on the scale.
The baby's weight is displayed.
Wait until the status LED is illuminated green.
3. Scan your user ID.
Your user ID has been scanned successfully if "Id:U" appears in the
display.
4. Scan the baby's patient ID.
The patient ID has been scanned successfully if "Id:P" appears in the
display.
NOTICE!
Data loss
If there is no input for approx. 10 minutes, partial results are
discarded.
►
Measure one baby's weight and length immediately consecutively.
5. Measuring the baby's length (in conjunction with
suring with the digital measuring rod" from page 55).
6. Press Enter to send measured values to the HIS or to seca software.
The status LED flashes green (approx. 5 seconds) while the data are
being transmitted.
7. Wait until the status LED is illuminated green.
All measured results are present and identification is complete.
Once the measured values have been sent successfully, the status LED
goes out.
NOTE
Which measured values are sent depends on the presets in the
seca connect 103
your administrator or hospital technician.
►
Press the Start key.
NOTE
In battery mode, the scale remains on standby for 60 seconds. If there
is no input during standby time, the scale switches off automatically.
Standby time can be adjusted(see "Setting standby time (AOff)" on
page 59).
appears in the display.
0.000
software. If you have any queries, please contact
appears in the
seca
symbol appears in
only, see "Mea-
seca 234