3M MicroTouch M1700SS Bedienungsanleitung Seite 24

3M™ MicroTouch™ Display M1700SS User Guide
Table 3. Common Touch Sensor Installation Issues
Common Installation Issues Possible Solutions
Touch sensor does not respond
to touch
Touch sensor is not accurate
Cursor does not follow finger
movement or does not reach the
edges of the sensor
Cursor is not located directly
underneath your finger
Cursor is extremely jittery or
erratic
Document #19-268
 Review the installation procedures. Are all cables connected
properly?
 After you installed Touch Software, did you restart your PC to
activate the touch sensor driver?
 Are the communication settings correct? Is the touch sensor trying
to use the COM port or IRQ of another device (for example, a
mouse)? If so, a hardware device conflict will result and the touch
sensor will not work.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Open the touch sensor control panel and make sure all cursor
offsets (vertical, edge/horizontal) are turned off.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Stabilize the cursor by adjusting the operating frequency of the
touch controller using the touch sensor control panel.
Rev AN
22