Connecting The Display - 3M MicroTouch M1700SS Bedienungsanleitung

3M™ MicroTouch™ Display M1700SS User Guide

Connecting the Display

The M1700SS Display comes with the cables already connected (with the exception of
the audio cable), however, there may be times when you need to reconnect these cables
for some reason. To connect the M1700SS Display:
Turn off the computer before connecting or disconnecting any device.
1.
Figure 11. Identifying Your Display Connections
Headphone
Connect the video cable to the video connector on the display and the other end to
2.
the video card in your computer.
Connect the touch sensor cable (either serial or USB) to the display and the other end
3.
to an available port on the back of your computer. If you are using a USB
connection, make sure you have installed the Touch Software drivers before
connecting the touch sensor cable.
Plug the AC/DC power supply into the M1700SS Display. Be sure to use the power
4.
supply included with the display.
Connect the power cable to the AC/DC supply. Connect the other end to the
5.
appropriate AC outlet.
Document #19-268
Line In
Power
Rev AN
Touch Sensor
Video Connection
14