En - R6; Obey The Safety Instructions; Check If Capacitors Need To Be Reformed - ABB ACQ580-01 Kurzanleitung Für Die Installation

EN – R6...R9 Quick installation guide
This guide briefly describes how to install the drive. For complete information on
installation, see ACQ580-01 (0.75 to 250 kW) hardware manual (3AXD50000035866
[English]). For start-up instructions, see chapter
89.
To read a manual, go to
document number.

Obey the safety instructions

WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur:
• If you are not a qualified electrician, do not do electrical installation work.
• Do not work on the drive, motor cable or motor when main power is applied. If
the drive is already connected to the input power, wait for 5 minutes after
disconnecting the input power.
• Do not work on the control cables when power is applied to the drive or to the
external control circuits.
• Use the lifting eyes of the drive when you lift the drive. Do not tilt the drive. The
drive is heavy and its center of gravity is high. An overturning drive can cause
physical injury.
• Make sure that debris from borings and grindings does not enter the drive when
installing.
• Make sure that the floor below the drive and the wall where the drive is installed
are non-flammable.

Check if capacitors need to be reformed

If the drive has not been powered (either in storage or unused) for over one year, you
must reform the capacitors.
You can determine the manufacturing time from the serial number, which you find on
the type designation label attached to the drive. The serial number is of format
MYYWWRXXXX. YY and WW tell the manufacturing year and week as follows:
YY: 13, 14, 15, ... for 2013, 2014, 2015,
WW: 01, 02, 03, ... for week 1, week 2, week 3,
EN – R6...R9 Quick installation guide 11
www.abb.com/drives/documents
EN – Quick start-up guide
and search for the
...
...
on page
R0-
R4
R6-
R9
R6-
R9
EN
DE
ES
FR
IT
RU
SV
ZH