Connected Repair [Core]; General Information - Bosch ACS 663 Originalbetriebsanleitung

en 56 | ACS 663 | Initial settings
9. Select the network associated with the router with
the Up or Down arrow buttons and confirm with
10. Enter the router WiFi password, confirm with
and wait for the connection to be established.
i
Make use of Manual Connect function whenever the
WiFi network is not automatically detected through
the Search WiFi Networks function. Manually
enter the WiFi network name and password paying
attention to upper and lower cases and then confirm
with .
11. The station informs the operator with a message
that the connection has been successfully
completed and the status bar will appear
12. Select
to exit.
"
The configuration to WiFi network is completed.
i
The efficiency and quality of wireless
communication may be affected by the presence
of radio disturbances. The protocol provides for
handling errors, but can cause communication
problems that sometimes require new attempts to
connect. If there are critical features that may affect
normal operation, the source of electromagnetic
environmental noise must be sought, reducing its
intensity.
i
Always check that the antennas, on the machine side
and on the workshop router side, are not obstructed
by shielding or metallic materials in general and
are not at an indicative distance greater than
10 m. If insufficient, it is recommended to improve
the coverage of the radio signal in the workshop
installing directional antennas or signal repeaters.
!
Make sure that the workshop network has active
security protocols (e.g.: WPA, WPA2) in order to
ensure data security.
|
SP00D00616 2019-07-02
5.17

Connected Repair [CoRe]

. 5.17.1

General information

Connected Repair, hereinafter CoRe, is a garage
management system that allows to connect all the
equipment and computers in the same network to
speed up and improve the management, sharing and
digitization of data and services to be carried out on
the vehicle.
Generally a CoRe network is formed by a server and
a number of clients equal to the number of PCs or
devices that can connect to it.
ACS 663 is to be considered as a client which is able to
autonomously connect to the CoRe server after having
configured the basic settings and exchange with it the
. data necessary to carry out Air Conditioning services or
simply A/C services.
Once the vehicle has been accepted from any
workstation, the CoRe server sends the vehicle data
and the data of the required interventions to all other
workstations and equipment connected to it, in this
way the operators and the equipment are already ready
to work on the vehicle without having to enter again
the data needed to identify the vehicle and/or the
customer.
The required interventions are then made available
in a few seconds and are subsequently saved in the
central memory by the CoRe server to optimize the
time needed for vehicle and customer recognition
in any subsequent appointments, where it will be
sufficient to enter the license number or VIN from any
workstation, to view the whole history of the vehicle,
the technical interventions and to view all the reports
of the equipment used in the previous works.
i
ACS 663 must be configured to access the same
WiFi network to which the CoRe server is connected
(see chapter "WiFi Configuration").
Robert Bosch GmbH