Handling And Operation; Switching The Appliance On And Off; Optimal Working Procedures - Parkside PAS 500 C2 Bedienungsanleitung

NOTICE
► On the assembly or release of the suction hose,
end piece and not the suction hose itself
damaged by twisting or bending.
♦ Insert the suction pipe

Handling and operation

In this chapter you receive important information about the handling and opera-
tion of the appliance.
Switching the appliance on and off
♦ Insert the power plug into a mains wall socket.
♦ To switch the appliance on, place the On/Off switch
♦ To switch the appliance off , place the On/Off switch

Optimal working procedures

WARNING
► The vacuuming up of glowing ash and combustible, explosive or health
hazardous materials is strictly prohibited.
► Only vacuum cold ashes. Cold ash is ash, which has cooled for suffi ciently
long and contains no embers. This can be determined by combing over the
ash with a metal tool before the appliance is used. From cold ash there is
no perceptible heat radiation.
♦ Place the appliance on a level and heat-resistant surface.
♦ Always use the suction pipe
a distance of approximately 1 cm above the ashes.
♦ Vacuum only ashes cooled to below 40°C.
♦ When vacuuming, constantly check the metal container
hose
♦ In the event of the appliance heating up, switch it off and disconnect the
plug from the mains power socket. Let the appliance cool down outdoors
under supervision.
♦ During work pauses you can insert the suction pipe
storage
♦ When transporting the appliance always use the carrying handle
PAS 500 C2
12 into the rigid end piece of the suction hose
12
11 for warming.
on the container lid
2
grasp the black plastic
11
11 . The suction hose
6
6
for vacuuming. Hold the suction pipe
12
5 .
11 could be
11 .
at the position "ON".
at the position "OFF".
12 at
10 and the vacuum
into the accessory
9
.
GB
9