Switching Off The Engine; Cleaning And Servicing; Overload Protection - Parkside PSE 2900 A1 Originalbetriebsanleitung

4. Push back the choke lever (17)
after starting the engine (into the
right position).
This procedure is suitable for both cold
and warm starts.

Switching off the engine

Allow the power generator to idle for a
short time before shutting it down so that
the unit can cool down.
1. Move On/Off switch (
the "OFF" position.
2. Close the petrol tap (16).
Connection to power-
consuming devices
CAUTION! These sockets may be
loaded continuously (S1) with 2600
W and short-term (S2) for max. 5
minutes with 2900 W.
Connect devices to the 230 V sockets (
Some electrical devices (motor jigsaws,
drills etc.) may have a higher power
consumption if they are used under dif-
ficult conditions.

Overload protection

The power generator is equipped with an
overload protection. This switches off the
sockets ( 7) in the event of an overload.
Pressing the overload switch (6) al-
lows the sockets (7) to be put back
into operation.
CAUTION! If this occurs, reduce
the electrical output consumed from
the power generator or remove the
defective connected devices.
CAUTION! Defective overload swit-
ches may only be replaced by the
Service Centre.

Cleaning and Servicing

Before all cleaning and main-
tenance work, switch off the
13) to engine and pull the spark
plug connector (
spark plug (
Switch off the power genera-
tor immediately and contact
your Service Centre:
-
-
Perform the following cleaning and mainte-
7).
nance work regularly. This will guarantee
long and reliable use.
Cleaning
The power generator must
not be sprayed with water
or immersed in water. Other-
wise there is a risk of electric
shock.
• Keep the ventilation slits, motor
housing and handles of the power
generator clean. Use a damp cloth or
brush to do this.
GB
30).
In case of unusual vibrations or
noises.
If the engine appears overloaded
or misfires.
IE NI
29) off the
11