Before Use; Installation; Electrical Safety; Environmental Protection - Parkside IAN 103318 Originalbetriebsanleitung

Please read all safety in-
formation and instructions.
Failure to observe the safety information and in-
structions can result in electric shock, fire and / or
serious injury.
Keep all safety advice and instructions in
a safe place for future reference.

before use

Installation

You will need two open ended spanners
for install this device (spanner size 12).
Install the stand
17
bar as shown in figures F–I.
19
Install all parts before pouring in the fuel and
oil to avoid the fluids leaking.
To install the wheels first push the wheel axle
through the brackets on the underside of the
generator and install the wheels
in figure G.
Ensure that when installing the push bar
slanting side (fig. I / Pos. I1) is slanting outwards.

Electrical safety

Electrical cables and attached devices must be
defect free.
Never connect the generator to the mains
(power point).
Keep the cables as short as possible.

Environmental protection

Dispense of polluted maintenance and operating
materials in a suitable collection point.
, wheels and the push
15
as shown
15
19
Safety instructions / Before use / Operation

Earthing

Earthing is needed to disperse static discharge.
Connect a cable from one side of the earthing
connector
4
and from the other side to an external ground.

Operation

ATTENTION! When being used for the first
time, motor oil (15 W-40, approx. 0.6 l) and petrol
(unleaded normal petrol) must be put in.
Check the fuel level and the oil, and if necessary
top them up.
Make sure you have adequate ventilation.
Ensure that the spark cable is securely in the
spark plug.
Unplug any electric device connected to the
generator.
16

Start the engine

ATTENTION! When starting with the express
the start you can injure your hand with the sudden
13
kick back.
Wear protective gloves when starting.
Open the petrol tap
wards.
Put the on / off switch
Turn the choke lever
position).
Start the engine with the express start
sharply pulling the handle. If the engine has not
started pull the handle again.
Push the choke lever
has started (in the right position).

To load the generator

Connect the device to the 230 V∼ socket
ATTENTION! This socket can be loaded con-
tinuously (S1) with 2600 W and short term (S2) for
a maximum of 2 minutes with 2800 W.
of the generator (fig. C / Pos. 4)
by turning the tap down-
14
to the on position.
11
to I I (in the left
12
back once the engine
12
by
13
.
3
GB 31