Edirol R-4 Bedienungsanleitung Seite 62

System settings
Menu item
Project Name
2 Player Setup
Menu item
Play Mode
Repeat
X2 Play
3 Speaker
Menu item
Speaker
Switch
4 LCD Setup
Menu item
Contrast
BackLight
BackLight
Timer
62
Value Function
This specifies how names will be assigned to the project files that are recorded.
You can specify that the name will be based on the date and time, or on the
Project Name you specify.
If you choose Date, a project recorded at one twenty-three (and 45 seconds) a.m.
on January 1, 2005 will be given a name of "050101012345".
If you use the Date setting, the name of the project will tell you the time at which
Date,
Name1–8 it was recorded; this is convenient when you've recorded a large number of
projects and are looking for a specific one.
If you use the Name setting, the project name will be the name you specified in
"7 Project Name" (p. 63) plus an ascending serial number. If you specify a clear-
ly identifiable project name, the names will follow an easily recognizable order,
such as : SCENE001, SCENE002, ... etc.
Value Function
This selects the playback mode.
Single
Only the selected project will play.
All projects in the folder that contains the currently selected project will play se-
Sequential
quentially.
This selects whether playback will repeat.
If Play Mode is Single, only that project will be played repeatedly. If Play
OFF, ON Mode is Sequential, each project in the folder that contains the currently select-
ed project will play sequentially, and then the projects in that same folder will
play sequentially again.
This enables/disables the double-speed playback function that is activated by
pressing the [PLAY] button twice. An indication of PLAY x2 will appear at the
OFF, ON
bottom of the display.
Press the [PLAY] button once again to return to normal playback.
Value Function
This switches the internal speaker on/off.
* Even if this setting is on, no sound will be produced by the internal speakers
OFF, ON during recording-standby or recording if the Recording Setup parameter In-
put Select is set to Int-Mic; the speakers also will remain silent while head-
phones are being used.
Value Function
This adjusts the contrast of the LCD. Higher settings will emphasize the white
1–5–10
areas of the display.
This adjusts the brightness of the LCD backlight.
The OFF setting turns the backlight off.
OFF, 1–10 Higher settings will make the backlight brighter, and will consume more power.
If you're operating the R-4 on battery power, pay attention to the remaining
amount of battery capacity.
Specifies the time after which the display backlight will be turned off when the
OFF, 2 sec,
R-4 has not been operated for a certain length of time.
5 sec, 10 sec,
If you're operating the R-4 on battery power, use this setting to conserve battery
20 sec
life.