Herunterladen Inhalt Inhalt Diese Seite drucken

Playing Back; Connections Before Playback - Edirol R-4 Bedienungsanleitung

4-channel portable recorder and wave editor
Inhaltsverzeichnis

Werbung

Playing back

This section explains various procedures and methods by which you can play back the projects in the R-4's
internal hard disk and the audio material you recorded on the R-4. \Make the correct settings and
connections before you play anything back.
• Connections before playback.............................. (p. 34)
• Settings before playback ...................................... (p. 36)
• Playing back ............................................................. (p. 38)

Connections before playback

Connecting headphones
Headphones are a convenient way to monitor while you're recording or immediately after recording.
1.
Turn the [MONITOR] level knob all the way to the left to minimize the volume.
2.
Connect your headphones to the PHONES jack.
3.
Slowly turn the [MONITOR] level knob toward the right to adjust the volume.
Connecting amplified speakers
Here's how to connect amplified speakers that have line input jacks or a digital input jack.
1.
Switch off the power on the R-4.
2.
Minimize the volume of the speakers you want to connect, and turn off their power.
3.
Depending on the type of speakers you are using, connect the R-4's [LINE OUT] line input jacks or
[DIGITAL OUT] digital output jack to your amplified speakers.
4.
Switch on the R-4's power.
5.
Next, switch on your speakers, and gradually increase the volume to the desired level.
* The R-4 does not provide a way to adjust the volume of the audio that is output from its line output jacks.
Connecting a mixer or other analog device
(analog connection: line output jacks)
Here's how to connect a mixer or other audio device that has line input jacks.
1.
Switch off the power on the R-4.
2.
Minimize the volume of the mixer or other device you're going to connect.
3.
Connect the R-4's [LINE OUT] line input jacks to your mixer.
You'll need separately available audio cables (not included) for connecting to the R-4's line output
jacks.
4.
Switch on the R-4's power.
5.
Next, switch on your mixer, and gradually increase the volume to the desired level.
* The R-4 does not provide a way to adjust the volume of the audio that is output from its line output jacks.
34

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis