Copying A Project (Copy) - Edirol R-4 Bedienungsanleitung

The Finder screen

Copying a project (Copy)

fig.finder-1.eps
1
With the main screen shown in the display, press the [ENTER/
FINDER] button. The Finder screen shown in the illustration will
appear.
Projects are shown in descending alphabetical order.
fig.finder-select.eps
2
In the Finder screen, use the [CURSOR] up/down buttons or
the [SCRUB] dial to select the copy-source project (the project
you want to copy). Then press the [ENTER] button.
If the desired project is in a folder, the hard disk (HD),
or the CompactFlash card (CF), you can press the [CURSOR] right button to move into the
selected folder (i.e., move to a lower-level folder).
If you want to move back to the upper-level folder, press the [CURSOR] left button.
fig.finder-cf.eps
* If you want to select the CompactFlash card, select the hard disk (HD)
and then press the [CURSOR] right button; the contents of the
CompactFlash card will appear. However, this will not be displayed if
no CompactFlash card is inserted.
fig.finder-copy1.eps
3
When the screen shown in the illustration appears, use the
[CURSOR] buttons to choose 4 Copy.
fig.finder-copy2.eps
4
Use the [CURSOR] up/down buttons or the [SCRUB/VALUE]
dial to select the copy-destination folder (the folder to which you
want to copy the project). Then press the [ENTER] button to
execute the Copy operation. As the copy destination, you may
also select HD (hard disk) or CF (CompactFlash).
* If you decide to cancel without executing, press the [EXIT] button.
fig.finder-copy3.eps
Don't turn off the power while a project is being copied.
* If the copy destination contains an identically named project, a number
such as -1 or -2. will be appended to the name of the copied project.
44