Inhaltsverzeichnis
Werbung
Editing
Merge
If the currently selected project consists of multiple files (MONO x2, MONO x3, MONO x4, STEREO x2),
this command merges them into a single channel.
How Rec Mode will change
Before Merge
MONOx2
MONOx3
MONOx4
STEREOx2
* Since MONO x1, STEREO x1, or 4 ch. projects cannot be merged, the Merge command will not appear in the menu
if you've selected this type of project.
fig.merge-1.eps
1
Press the R-4's [WAVE EDIT] button. The Wave Edit Menu
screen will appear.
2
Use the [CURSOR] buttons to choose 4 Merge, and press the
[ENTER] button.
fig.merge-2.eps
The editing screen shown at right will appear.
If you want to adjust the level (Mix Level) of the channels in the
project, you can do so. Use the [CURSOR] up/down buttons or
the [SCRUB] dial to specify the value.
For example, in a stereo two-channel project (STEREO x2), you
might set the Mix Level to -6.0 dB so that the level of each channel
will be lowered by 6 dB when they are merged.
* If you decide to cancel, press the [EXIT] button.
fig.merge-3.eps
3
To execute, press the [ENTER] button.
If you decide not to use the Merge command, press the [EXIT]
button.
Even when the screen shown at the right is displayed, you can halt
execution by pressing the [EXIT] button.
* Don't turn off the power while a project is being saved or while
processing is being performed.
* It may take some time to save the project if it contains a large amount of data.
54
After Merge
MONOx1
STREOx1
fig.media-full.eps
If the internal hard disk does not have enough space to save the project, a
message of "Media Full!" will appear.
Werbung
Kapitel
Inhaltsverzeichnis
