Edirol R-4 Bedienungsanleitung Seite 57

4: Enhancer
Parameter
No.
name
1 SENSE
2 MIX
3 LEVEL
5: Comp&DeEsser
Parameter
No.
name
DE-ESSER
1
SW.
2 THRESHOLD
3 RATIO
4 ATTACK
5 RELEASE
6 GAIN
7 LEVEL
Range of values
0–100
0–100
0–120
Range of values
OFF, ON
0–100
1.0:1, 1.2:1, 1.5:1, 2.0:1, 2.8:1,
4.0:1, 8.0:1, 16.0:1, Inf:1
0.25–100ms
50–5000ms
-6.0dB–+18.0dB
(The value will change in
steps of 0.5dB)
0–120
Default
Explanation
values
Adjusts the sensitivity of the enhanc-
50
er effect.
Adjusts the amount of phase-shifted
50 sound that is to be mixed with the in-
put.
100 Adjusts the overall volume.
Default
Explanation
values
Turn this ON to reduce unpleasant
ON
sibilance.
Specifies the volume (threshold lev-
el) at which the compressor will be-
gin to operate. Compression will be
50 applied to the input when it exceeds
this level. Lower threshold settings
mean that the compressor will be ap-
plied even at lower levels.
Adjusts the ratio at which the sound
will be compressed when the input
4.0:1 exceeds the threshold level. Higher
ratios mean that the sound will be
compressed more strongly.
Adjusts the time over which the
amount of compression specified by
Ratio will be reached once compres-
sion is triggered by the input exceed-
10ms
ing the threshold level. Higher
settings of Attack mean that com-
pression will be applied more slow-
ly.
Adjusts the time over which com-
pression will be removed once the
input falls below the threshold level.
100ms
Higher settings of Release mean that
the sound will revert to its uncom-
pressed state more slowly.
Adjusts the gain following compres-
0.0dB
sion.
100 Adjusts the overall volume.
Effects setting
57