Edirol R-4 Bedienungsanleitung Seite 61

Menu item Value
MONOx1
MONOx2
MONOx3
MONOx4
STEREOx1
Rec Mode
STEREOx2
4CHx1
44.1kHz
48kHz
96kHz
The "*" symbol means that this is not available if Input Select is set to Int-Mic or Digital.
Pre Record- OFF, 1–29
ing sec
Function
One-channel recording to
one monaural file
Two-channel recording to
two monaural files
Three-channel recording to
three monaural files
Four-channel recording to
four monaural files
Two-channel recording to
one stereo file
Four-channel recording to
two stereo files
Four-channel recording to
one four-channel file
MONOx1 MONOx2 MONOx3 MONOx4 STEREOx1 STEREOx2
You can specify the length of time that the sound will be captured "retroactive-
ly," starting from before the moment you pressed the [REC] (record) button.
This setting specifies the number of seconds that will be captured retroactively.
* The maximum time will depend on the sampling frequency, the sample size
(bit depth), and the mode setting.
Rec Freq. Rec Bit
44.1 16
44.1 16
48 16
48 16
48 24
48 24
96 24
96 24
* The R-4 consumes power even during pre-recording. If you're running on bat-
teries, you'll need to pay attention to the remaining battery amount.
This selects the structure of the project file that is
created when you record. A monaural WAV file
will be created for each channel. Choose these
settings if you're using a separate mic for the vo-
cal and performance or each speaker in a conver-
sation, so that a separate file will be created for
each channel. These settings will create monaural
WAVE files. If Input Select is Analog, up to four
monaural files will be created. If Input Select is
Int-Mic or Digital, up to two monaural files will
be created.
* You can't select MONO x3, or MONO x4, or
STEREO x2 if Input Select is Int-Mic or Digital.
* You can't select MONO x3 or MONO x4 if Rec
Freq. is 96 kHz.
Two channels will be recorded as L and R in a ste-
reo WAV file.
If Input Select is Analog, one stereo file with
channel 1 as L and channel 2 as R will be created.
The inputs of channels 3 and 4 will be ignored.
If Input Select is Int-Mic or Digital, one stereo
WAV file will be created.
If Input Select is Analog, a stereo file with chan-
nel 1 as L and channel 2 as R will be created, and
another stereo file with channel 3 as L and chan-
nel 4 as R will also be created.
* You can't select STEREO x2 if Input Select is Int-
Mic or Digital.
Channels 1–4 will be recorded as a single WAVE
file. Be aware that not all computer software is
able to handle four-channel WAV files.
* You can't select 4CH x1 if Int-Mic is set to Digi-
tal.
✽ ✽
✽ ✽
Rec Mode Pre Recording
STEREO x1 29
STEREO x2 14
STEREO x1 27
STEREO x2 13
STEREO x1 18
STEREO x2 9
STEREO x1 9
STEREO x2 4
System settings
4CH
✽ ✽
✽ ✽
✽ ✽
61