Inhaltsverzeichnis
Werbung
fig.wave-4.eps
4
In the same way, move to the end (point
want to extract, and press the [ENTER] button.
* The value of point
fig.wave-trim2.eps
fig.wave-5.eps
5
A screen asking you to confirm the specified points will appear.
fig.wave-6.eps
If you are satisfied with the points you specified, press the
[ENTER] button to confirm the settings. If you decide to try again,
you can press the [EXIT] button once and re-specify the end of the
2
). You can then press the [EXIT] button once
region (point
again and re-specify the beginning of the region (point
Even when the screen shown at the right is displayed, you can halt
execution by pressing the [EXIT] button.
* Don't turn off the power while a project is being saved or while
processing is being performed.
fig.wave-trim2.eps
6
The extracted region will be saved as a
new project with the same name as the
original project but with "-1" appended
to it. The original project will remain
unchanged.
For example, if the original project is
named Project, the new project will be
named Project-1.
2
) of the region you
2
is shown in terms of samples (data).
Project
Project
fig.media-full.eps
If the internal hard disk does not have enough space to save the project, a
message of "Media Full!" will appear.
Project
1
).
1
2
Editing
2
1
2
1
2
Project-1
49
Werbung
Kapitel
Inhaltsverzeichnis
