Edirol R-4 Bedienungsanleitung Seite 52

Editing
Combine
This command appends another project (of the same format) onto the end of the currently selected project.
The two files will be joined to create a single new file.
You cannot perform playback, stop, or operate the scrub dial or shuttle dial while using this command.
1
Select the project (the "base project") to which you want to append another project.
In the main screen, use the [NEXT] button or [PREV] button to select the desired project. Alternatively,
you can use the cursor buttons in the Finder screen.
fig.wave3-1.eps
2
Press the R-4's [WAVE EDIT] button. The display shows the
Wave Edit Menu screen.
3
Use the [CURSOR] buttons to choose 3 Combine, and press the
[ENTER] button.
fig.wave3-2.eps
The display shows an editing screen like the one at right.
* If you decide to cancel the operation, press the [EXIT] button.
fig.wave3-3.eps
4
Use the [CURSOR] buttons to select the project that you want to
append, and press the [ENTER] button.
fig.wave3-4.eps
If you decide to cancel the operation, press the [EXIT] button.
Even when the screen shown at right is displayed, you can halt
execution by pressing the [EXIT] button.
* Don't turn off the power while a project is being saved or while
processing is being performed.
* It may take some time to save the project if it contains a large amount
of data.
The "base project" and the "project to be appended" must have the same sampling frequency,
sample size (bit depth), and number of channels.
52
fig.wave3-error.eps
If you select a project that cannot be appended, the message shown
here will appear.
Base project
Project
to append