Inhaltsverzeichnis
Werbung
Editing
Projects you record using the R-4 can be edited directly on the R-4.
Editing
No.
command
1
Trim
2
Divide
3
Combine
4
Merge
* Executing any of these editing commands will leave the original project file unchanged.
* There is no Undo function.
Editing procedure
Trim
This command extracts the region between the two points you specify in the waveform, and creates a new
project using this extracted region.
You can perform playback, stop, or operate the scrub dial and shuttle dial even while using this command.
However, you cannot perform A-B Repeat or marker-related operations.
fig.wave-1.eps
1
Press the R-4's [WAVE EDIT] button. The Wave Edit Menu
screen appears in the display.
2
Use the [CURSOR] buttons to choose 1 Trim, and press the
[ENTER] button.
fig.wave-2.eps
The editing screen shown at the right will appear.
Time axis zoom (1/1–1/65536)
Use the [CURSOR] left/right buttons to adjust this
Waveform level zoom (x1–x64)
Use the [CURSOR] up/down buttons to adjust this
* If you decide not to adjust the settings, press the [EXIT] button.
fig.wave-3.eps
3
While playing or fast-forwarding, press the [ENTER] button
when you reach the beginning (point
to extract.
Alternatively, you can use the scrub dial or shuttle dial to specify
the point instead of doing so during playback.
fig.wave-trim1.eps
* The value of point [
48
Result
Specify two points in the waveform, extract the region, and create a new
project using that region.
Specify one point in the waveform, and divide the project at that point.
Two new projects will be created.
Append another project following the end of the currently selected
project. The two files will be joined to create a single new file.
A project consisting of multiple files will be merged into a single channel.
1
) of the region you want
1
] is shown in terms of samples (data).
Time axis zoom
1
Project
See
p. 48
p. 50
p. 52
p. 54
Waveform level
zoom
Elapsed
time
Total time
1
Werbung
Kapitel
Inhaltsverzeichnis
