Inhaltsverzeichnis
Werbung
Output level meters
Clip level indicators
Power source
In the main screen, you can press the [DISPLAY] button to switch the progress bar area so it shows the
remaining project time (REMAIN).
fig.play-disp2.eps
Remaining time
The mixer screen
From the main screen, press the [DISPLAY] button twice to move to the Mixer screen.
This screen lets you adjust the volume balance for monitoring.
fig.play-disp3.eps
Channel level
sliders
Channel level sliders
These are the output level meters. They show the final output levels of the L
and R channels, to which the various channels have been mixed. You can use
the monitor level sliders of the mixer screen to adjust the level of each channel.
From the left, the level meter is calibrated at -36, -24, -12, and -6 dBFS.
Indicates how power is being supplied to the R-4. The plug icon is shown if
power is being supplied by the AC adaptor, and the battery icon is shown if
power is being supplied by batteries.
Remaining time
During playback, this indicates the remaining time from the current location
to the end of the project.
Channel names
Use these to adjust the playback level of each channel. Use the left/right
[CURSOR/FINDER] buttons to select a slider, and turn the [SCRUB/VALUE]
dial to adjust the value. Each slider provides adjustment within the range 0–
120. The default value is 100.
* The settings are not stored in the project; they are remembered by the R-4
itself. When you turn off the power, the settings will revert to their default
values.
* These settings do not affect the recording levels.
Monitor output indicators
Introducing the R-4
Channel level meters
Output level meters
19
Werbung
Kapitel
Inhaltsverzeichnis
