Malaguti PHANTOM MAX 200 Bedienungsanleitung Seite 141

Changing the oil and cleaning the oil filtering net
after the first 1,000 Km and every 3,000 Km
• Warm up the engine for some minutes.
• Stop the engine. Place an oil collecting pan under the engine.
• Remove the drain plug and let the oil drain out (1 - Fig. 27a).
• Clean the oil filtering net (1 - Fig. 27b) with a solvent.
• Check the O-ring, (3 - Fig. 27b), and replace it, if worn out.
• Reinstall the O-ring, the compression spring (2 - Fig. 27b), the
oil filtering net, and the drain plug.
Note: make sure that the O-ring is positioned correctly.
• Tighten the drain plug applying the following
torque: 32 Nm / 3.2 kgm
• Fill the engine with oil and re-insert the dipstick.
• Start the engine and warm it up, then check if there is any leakage.
If so, stop the engine, trace the fault, and correct.
Every 3,000 km, the message OIL is displayed on the
digital dashboard. This warning light indicates that it is
time to change the engine oil.
This warning light is displayed on the dashboard until the
above-mentioned operation is carried out by Malaguti
Authorised Service Centre.
Used oil is toxic for the environment, therefore we suggest
you contact a Malaguti Authorised Service Centre for oil
disposal according to the rules in force.
1
1
2
3
Fig. 27a
EN
Fig. 27b
37